Page 3 of 3

Re: AS0030 - Graham - Meyers Manx

Posted: Sun May 29, 2016 3:52 pm
by VWNuts
Another coat of paint on the floorpan before the lift kit and body go back on.

Image

Re: AS0030 - Graham - Meyers Manx

Posted: Sun May 29, 2016 10:03 pm
by Smiley
Looking good mate.
Can't wait to see this up the beach!


Smiley :)

Re: AS0030 - Graham - Meyers Manx

Posted: Wed Jun 01, 2016 7:50 pm
by VWNuts
Back on 4 wheels again. Disc brake front and Type3 drum rear all bled and working

Image

Re: AS0030 - Graham - Meyers Manx

Posted: Thu Jun 02, 2016 6:03 pm
by VWNuts
Kombi CV joints inner & outer now installed

Image

Re: AS0030 - Graham - Meyers Manx

Posted: Thu Jun 02, 2016 7:46 pm
by bajabone
Nice. What box you running Graham?

Re: AS0030 - Graham - Meyers Manx

Posted: Thu Jun 02, 2016 8:23 pm
by VWNuts
1800 Kombi box for the time being

Re: AS0030 - Graham - Meyers Manx

Posted: Thu Jun 02, 2016 8:26 pm
by VWNuts
Modified my gearshift shaft to operate the Kombi box above the tunnel

Image

Re: AS0030 - Graham - Meyers Manx

Posted: Sun Jun 05, 2016 7:49 am
by PUD
That linkage looks the go allowing for easy adjustment....assume the shaft was cut back, drilled & threaded? Don't think mine has the thread in the end but I might have to look at doing something similar :)
The build's all looking the goods so far :D Pud

Re: AS0030 - Graham - Meyers Manx

Posted: Sun Jun 05, 2016 2:07 pm
by VWNuts
I cut the end of the shaft off, machined a slug to weld in the end and threaded the centre for the bolt to go into

Re: AS0030 - Graham - Meyers Manx

Posted: Sun Jun 05, 2016 2:54 pm
by VWNuts
Another view

Image

Re: AS0030 - Graham - Meyers Manx

Posted: Wed Jun 08, 2016 8:46 pm
by PUD
Looks like you have a bit more offset than me but I like the linkage, wondering if there's room to wind the end on in the tunnel or if the shaft gets fed in from the back without the gearbox fitted?

Re: AS0030 - Graham - Meyers Manx

Posted: Thu Jun 09, 2016 6:09 am
by VWNuts
Was just enough room to wind the end onto the shaft inside the tunnel

Re: AS0030 - Graham - Meyers Manx

Posted: Mon Nov 12, 2018 4:43 pm
by PUD
G'day Graeme,.... Been a hell of a lot of water under the bridge since this '16 post.... Would love to have a peek at all the stuff you've had going on and building .... :D Pud